Solution for belt slippage:

1： When the spiral or hydraulic tensioning belt conveyor slips, the tensioning stroke can be adjusted to increase the tensioning force. However, sometimes the tension stroke is not enough and the belt undergoes sexual deformation. In this case, a section of the belt can be cut off and re vulcanized

2： When using nylon tape or EP, a longer tensioning stroke is required. When the stroke is not enough, it can be re vulcanized or the tensioning stroke can be increased to solve the problem.

3： The slippage of the belt in the heavy hammer tensioning belt conveyor can be solved by adding a counterweight to the belt conveyor with a heavy hammer tensioning device when the belt slips, until the belt no longer slips. But it should not be added too much, so as not to subject the belt to unnecessary excessive tension and reduce its service life.

There are various reasons for deviation, which need to be handled differently according to different reasons:

1： Adjust the bearing roller group

2： Install the self-aligning roller set

3： The adjustment of tension at the belt is a very important step in adjusting the deviation of the belt conveyor.

4： Adjusting the position of the driving drum and the reversing drum is an important step in adjusting belt deviation.

5： Adjustment of the deviation of the bidirectional running belt conveyor.